Page 1 of 1

JTool segfaults on disassembling TaiG

PostPosted: Sat Feb 06, 2016 10:29 pm
by Siguza
I just tried to disassemble the TaiG untether binary for 8.4 with JTool 0.98.99999, and got a segfault.
The exact command I ran was: jtool -d -arch arm64 taig
The -v and -vv flags only produce one additional line of output, which I believe does not matter here:
Library dependency blob at offset 21ca8

That is all information I have.
For anyone else reading this, the untether binary can be downloaded from here and extracted with ar -x *.deb and subsequently tar -xf data.tar.gz.

Re: JTool segfaults on disassembling TaiG

PostPosted: Sat Feb 06, 2016 11:59 pm
by morpheus
Oops. Never fixed that. You can work around with NOOBJC=1 which would work fine, or by thinning binary first.
Incidentally, I supplied the binaries in my writeup about TaiG II , along with the DMG and other files.